User Program Mode (Recalling A User Program); Saving A Program; Restoring The Factory Settings - Vox VT20X Manual De Usuario

Switching to manual mode
Hold down the PRESET PROGRAMS button for at least one second to
switch to manual mode; the PRESET PROGRAMS, BANK and channel
buttons turn off.
When in manual mode, if a parameter (effect, noise reduction, valve
section setting, etc.) not set by a knob is changed, that setting is
automatically saved. That setting will be recalled the next time that
the manual mode is entered.

User program mode (recalling a user program)

In user program mode, the program saved in the channel of the bank,
which can be selected by pressing the BANK and channel buttons, is
recalled, and all amp and effect parameters are automatically switched to
the saved settings.
Switching to user program mode
Press the BANK button or a channel button to enter user program mode;
the BANK and channel buttons light up.
Recalling a user program
Press a channel button to switch the channel, and the program saved in the
channel is recalled. Press the BANK button to switch the bank, and the channel
with the same number as that selected in the previous bank is recalled.
If an optional (VOX VFS5) foot switch (sold separately) is connected
Tip
and being used, you can use your foot to switch the bank and channel.
For details, refer to "Using the foot switch (VOX VFS5)" on page 9.

Saving a program

After adjusting the various knobs and buttons on the top panel to create
your desired sound, it can be saved (written) as a user program.
When saving programs to channels within the same bank, start the
Tip
procedure from step 3.
1. Hold down the BANK button for at least 0.5 second. The BANK button
blinks.
2. Press the BANK button to select the bank where the program will be saved.
To cancel the write operation, press the TAP button.
Tip
3. Hold down the channel button of the save location for at least 2 seconds
(until the button changes from blinking to lit). The program is saved to
the channel, and the bank and channel for the save location are selected.
Any program previously saved at that location is overwritten.
In other words, the program previously saved at the location
selected in step 3 is erased.
The bypass setting of the effect and the POWER LEVEL setting
are not saved with the program.
If, while creating a sound in the preset programs mode or the
user program mode, you switch to another program or to manual
mode or turn off the amp before saving the sound that you are
creating, the changes that you made will be lost.

Restoring the factory settings

Here's how to restore all settings of the VT20X/VT40X to their factory-set
state.
When this operation is done, all programs saved to channels as well
as all settings, such as custom amp settings stored from the Editor/
Librarian software, will be reset to the factory defaults.
1. Turn off the power.
2. While holding down the CH1 and CH4 buttons, turn on the amp. After
the BANK and channel buttons blink, release the pressed buttons.
If you decide to cancel initialization at this point, press the TAP
Tip
button.
3. Hold down the BANK button for at least 2 seconds (until the button
changes from blinking to lit).
After the BANK and channel buttons change from blinking to lit,
initialization begins. Initialization is completed after about 1 to 2
seconds, and the amp enters the preset programs mode.
- 8 -