Philips MARCILLA SENSEO HD7872 Manual Del Usuario página 17

7.2 Flushing after descaling
Rinse the water reservoir under the tap and
1
then fill it to the top with fresh tap water.
Notes:
D
Do not refill the water reservoir with used
hot water or the used descaling mixture.
Tilt the water reservoir and place the bottom
2
back onto the machine (1). Then press the top
of the water reservoir towards the machine
(2).
Place the 1-cup pod holder q with a used
3
coffee pod in it in the coffee machine. Close
the lid and make sure it is properly locked.
Put a bowl with a capacity of at least 1.5 litres
4
under the spout to collect the water.
Press the 1-cup button q and the 2-cup
5
button qq at the same time for 3 seconds
until you hear a beep to start the flushing
cycle.
Remove the used pod and clean the pod
6
holder after the flushing cycle to prevent the
sieve in the centre from getting clogged.
Repeat steps 1 to 6 once more to ensure a
7
clean machine.
After the descaling cycle and the flushing
8
cycles, the CALC light goes out and the
machine switches off automatically.
17