Assembly; Operation - Hoover ONE PWR BH57105CK Manual Del Usuario

WARNING!
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in
serious personal injury.
WARNING!
Do not allow familiarity with this product to make
you careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING!
Always remove battery pack from the product when you
are assembling parts, making adjustments, cleaning, or
when not in use. Removing battery pack will prevent ac-
cidental starting that could cause serious personal injury.
WARNING!
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING!
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended can
result in serious personal injury.
Applications
You may use this product for the following purpose:
• Light-duty vacuuming of wet or dry surfaces.
Installing/Removing the Flexible Hose
See Figure 1, page 9
• Align the raised locking tab on the end of the flexible
hose with the slot on the vacuum port. Push in and twist
counterclockwise to lock.
• Insert the tapered end of the flexible hose into accessory.
• To disassemble, remove the accessory from the flexible
hose.
• Rotate the other end of the flexible hose clockwise to
unlock and pull away from the vacuum port.
PG.5
If any parts are damaged or missing, please call 800-406-2005.

ASSEMBLY

Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification
is misuse and could result in a hazardous condition
leading to possible serious personal injury.

OPERATION

Installing/Removing Battery Pack
See figure 2, page 9
• Set the On/Off switch to the Off position.
• Insert the battery pack into the product as shown.
• Make sure the latches on each side of the battery pack
snap into place and that battery pack is secured in the
product before beginning operation.
• Depress the latches to remove battery pack.
Charging the Battery Pack
See figure 3, page 9
• Charge the battery fully before first use. This will take up
to 3 hours. Due to federal regulations, the battery does
not come fully charged.
• Plug the charger into a power outlet.
• Attach the battery pack to the charger by aligning the
ribs on the battery pack to the grooves in the charger.
Slide the battery pack into the charger.
• When charging, the lights on the battery will illuminate
to show the state of charge. The light on the charger
will flash.
• If the light on the charger illuminates red, there is an
error with the battery or the charger. Wait 1 hour and try
again or call customer service for support.
• When charge is complete the lights on the battery will
turn off and the light on the charger will be solid.
• To remove the battery pack from the charger, press the
latches and pull up on the battery pack.
Starting/Stopping the Wet/Dry Vac
See figure 4, page 9
• To start the wet/dry vac: Press the On/Off switch to the
On position.
• To stop the wet/dry vac: Press the On/Off switch to the
Off position.
WARNING!