Cleaner Assembly; How To Assemble - Hoover Dual Power REMANUFACTURED Manual Del Propietário

CARTON CONTENTS FOR
DUAL POWER
A. Carpet Cleaner Base
B. Lower Handle
C. Clean Water/Solution Tank
D. Upper Handle
E. Handle Screw
F. Right and Left Screws
G. Carpet Cleaning Detergent
Remove all parts from carton and
identify each item shown.
Make sure all parts are located
before disposing of packing
materials.
NOTE: PHILLIPS SCREWDRIVER NEEDED FOR ASSEMBLY.
BASE AND LOWER HANDLE
ASSEMBLY
2.1 Stand base in upright position. Push lower handle
onto base.
2.2 Assemble the two lower handle screws and tighten.
2.3 Slide upper handle down onto unit. Place upper
handle screw into recess in back of upper handle and
tighten.
ATTACHING CLEAN WATER SOLUTION
TANK
2.4 Place solution tank into cleaner and tilt back
until it snaps into place.
BEFORE YOU BEGIN CLEANING
1. Vacuum thoroughly - For carpet, use a
HOOVER vacuum cleaner with an agitator for best
®
results. Vacuum upholstery with a vacuum cleaner
with cleaning tool attachments. Use a crevice tool
to reach into tufts and folds. Do not use the carpet
cleaner as a dry vacuum cleaner.
2. For upholstery, check cleaning code - Use your
HOOVER carpet washer only if the upholstery fab-
®
ric is marked with a "W" (for "wet" clean) or "S/W"
(for "solvent/dry" or "wet" clean). Do not clean fab-
ric marked "S" ("solvent/dry" clean only). If your
upholstery does not have a code, seek professional
assistance.
3. Test for colorfastness - Wet a white absorbent
cloth with the solution. In a small, hidden area, gen-
tly rub the surface with the dampened cloth. Wait
ten minutes and check for color removal or bleed
with white paper towel or cloth. If surface has more
than one color, check all colors.
4. When cleaning entire floor, move furniture out of
area to be cleaned (may not be necessary if only
high traffic areas are to be cleaned).
For furniture too heavy to move, place aluminum
foil or wax paper under legs. This will prevent wood
finishes from staining carpet. Pin up furniture skirts
and draperies.
5. Pretreat spots and heavy traffic areas with an
appropriate Hoover Cleaning Solutions, see
"Cleaning Solutions" section. Follow Directions on
bottle.
*Available at additional cost if not included with
your model.
6. To prevent staining, use plastic or aluminum foil
to protect wood or metal surfaces from possible
water spray.

1. CLEANER ASSEMBLY

1.1
A

2. HOW TO ASSEMBLE

7. To avoid wetting and possible damage to wood
floors underneath area rugs/carpet, either move area
rugs/ carpet to a non-wood hard floor surface or
place waterproof material (e.g. plastic) underneath
them before cleaning.
carpeting (including silk and wool), soft carpeting,
and loop Berber carpeting. Do not use on rugs or
6
D
B
C
E
2.1
2.3
ATTENTION
Prior to use, consult with Carpet Manufacturer
on cleaning recommendations for natural fiber
carpet when dry cleaning is recommended.
ATTENTION
Some Berber, Natural Fiber, and Soft Fiber
carpets can fuzz with wear. Some vacuums &
carpet cleaners can worsen this carpet wear.
Test a hidden area before using on a full room
& consult with your carpet manufacturer on
cleaning recommendations.
G
F
2.2