Storing And Recalling Broadcast Frequencies; Introduction Of Advanced Operations - Pioneer DEH-P65BT Manual De Instrucciones

Section
02 Operating this unit
3 Frequency indicator
4 Stereo (5) indicator
Shows when the selected frequency is being
broadcast in stereo.
5 LOC indicator
Shows when local seek tuning is on.
1 Press SOURCE to select the tuner.
2 Press BAND to select a band.
Press BAND until the desired band is dis-
played, FM1, FM2, FM3 for FM or MW/LW.
3 To perform manual tuning, push
MULTI-CONTROL left or right.
4 To perform seek tuning, push and hold
MULTI-CONTROL left or right for about one
second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You can cancel seek tuning by pushing
MULTI-CONTROL left or right.
# If you push and hold MULTI-CONTROL left or
right you can skip stations. Seek tuning starts as
soon as you release MULTI-CONTROL.
Storing and recalling broadcast
frequencies
You can easily store up to six broadcast fre-
quencies for later recall.
! Up to 18 FM stations, six for each of the
three FM bands, and six MW/LW stations
can be stored in memory.
1 When you find a frequency that you
want to store in memory press LIST.
2 Use MULTI-CONTROL to store the se-
lected frequency in memory.
Turn to change the preset number; press and
hold to store.
The preset number you have selected will
flash and then remain lit. The selected radio
station frequency has been stored in memory.
# You can also press and hold one of the preset
tuning buttons 1 to 6 to preset the desired fre-
quency.
12
En
3 Use MULTI-CONTROL to select the de-
sired station.
Turn to change the station; press to select.
# You can also change the station by pushing
MULTI-CONTROL up or down.
# You can also recall stations assigned to preset
tuning numbers PCH1 to PCH6 by pressing one
of the preset tuning buttons 1 to 6.
# If you do not operate the list within about 30
seconds, the display is automatically returned to
the ordinary display.
Introduction of advanced
operations
1 Press MULTI-CONTROL to display the
main menu.
FUNCTION or AUDIO appears on the display.
2 Use MULTI-CONTROL to select
FUNCTION.
Turn to change the menu option; press to se-
lect.
The function name appears on the display.
3 Turn MULTI-CONTROL to select the
function.
Turn MULTI-CONTROL to switch between the
functions in the following order:
BSM (best stations memory)—REGIONAL (re-
gional)—LOCAL (local seek tuning)—PTY
(program type selection)—TRAFFIC (traffic an-
nouncement standby)—AF (alternative fre-
quencies search)—NEWS (news program
interruption)
# If MW/LW band is selected, you can only se-
lect BSM or LOCAL.
# To return to the frequency display, press
BAND.
# If you do not operate functions within about
30 seconds, the display is automatically returned
to the ordinary display.