Installation And Electrical Connection - Pentair ControlPro CPRO-1010 Guia De Instalacion

Make sure to check and comply with your local technical regulations and building codes in particular
regarding minimal safety distances for installation of electrical components near a swimming pool.
Only a qualified service person should install the heat pump. Before installing this product, refer to the
Important Warning and Safety Instructions
Respect safety distance between the pool and the ControlPro system (electric appliance) as
required by local regulation
The Interface Module and Contactor have to be accommodated inside a DIN rail cabinet. 180mlm of free space is
required for the 2 components.
The Control Unit can be installed in the most convenient location. In case the supplied connection cable is not long
enough, replace it using a 4 x 0.5mm2 cable (AWG20). (Max 50m long).
The control unit should be installed protected from direct sunlight.
Although the unit is water resistant, it is required to protect it from rain or water projections. (water sprinklers).
Fix the unit on a flat vertical surface using the screws and anchor plugs supplied with the unit.
Always make sure to close the cover (4 screws) after interventions inside the control unit.
Tighten the 2 screws fixing the unit into its support to avoid accidental removal.
The picture below shows the connectors on the ControlPro Interface module and their function. The connectors are
detached from the unit to facilitate electrical connections. LED's on the Interface unit reflect the status of the different
inputs and outputs. A blinking main power LED indicates an error condition.
7