Pentair ControlPro CPRO-1010 Guia De Instalacion página 9

B6 Connecting a variable Speed Pump
In order to connect a Pentair or StaRite VS Pump to your ControlPro, carefully follow the diagram below.
The pump ON/OFF is managed by the contactor. The different speeds are activated by connecting the B6
connector onto the relay contact inside the VS pump wiring compartment. Power supply to the pump is
permanent.
Make sure to configure ControlPro for 'multispeed' pump functionality (see Configuration chapter in this
manual)
Set the time for each of the program steps on the VS pump itself to zero (see manual for VS pump)
B3 Pool Cover Input
Pools equipped with an automatic pool cover can be connected to ControlPro in order to adapt the filtration in
function of the pool cover. A pool that is covered will usually requires less filtration and water treatment. Most of
these pool covers are equipped with an external contact.
This contact should be open when the pool cover is open and closed when the pool is covered.
The pool cover contact has to be a dry contact (without any voltage). No other equipment can be connected to
this contact. Failure to do so may result in damage to the ControlPro and is not taken on warranty
External control
Terminal on
VS pump
9