Directing The Airflow - Beem Air Joy Hot & Cool Manual De Instrucciones

EN
NOTE
► The appliance continues to run
for roughly 10 seconds after
switching off.
► Wait until the appliance has
come to a complete standstill
before switching off at the main
switch and pulling the mains
plug out.
Setting the cold airflow
Continuous setting of the cold airflow
takes place via the regulator
the control panel (5). It is only possible to
regulate the cold airflow.
Switch on the appliance and the cold
‹
airflow as described above.
Turn the regulator
‹
increase the airflow. The stronger the
cold airflow is set, the more bars light
up blue on the control panel (5):
Setting the cold
airflow
low airflow
medium airflow
maximum airflow
Turn the regulator
‹
to lower the airflow.
BEEM - Elements of Lifestyle
button on
clockwise to
Display
1 blue bar
2 blue bars
3 blue bars
anticlockwise
Air Joy Hot & Cool
Warm airflow
Warm airflow CANNOT be set.
Only maximum hot air is produced and
blown out.
The 3 bars on the control panel light up
red ALWAYS.
NOTE
► The appliance is protected against
overheating. This switches off the
appliance to prevent overheating
(see section Safety equipment,
page21).
Switching the rotation movement
on/off
(see images A1 and A2)
The rotating movement is switched
‹
on via the
panel (5).
Press the
‹
off the rotating movement.

Directing the airflow

(see images B1 and B2)
The direction of the airflow is set via the
inclination adjustment on the foot (3).
NOTE
► Direct the airflow only when the ap-
pliance is switched off.
Hold the foot tight with one hand.
‹
Change the inclination of the appli-
‹
ance with the other hand until the
desired airflow angle has been set
(images B1 and B2).
button on the control
button again to switch
23