Machine Components; Machine Assembly; Attaching Handle To Base; Attaching Optional Solution Tank - Tennant 2260 Manual Del Operador

OPERATION

MACHINE COMPONENTS

4
5
6
10
11
12
7
8
1. Control Handle
2. Handle Height Adjustment lever
3. Safety Lock Levers
4. On/Off Levers
5. Solution Control Lever for Optional Solution Tank
6. Power Cord
7. Power Cord Storing Hook
8. Transport Wheels
9. Motor
10. Switch Box
11. Circuit Breaker Reset Button
12. Dual Speed Selector Switch
13. Scrub Head Base
14. Bumper
15. Solution Supply Connector for Optional Solution
Tank
10
3
1
4
2
14
9
13
15
14
Home Find... Go To..

MACHINE ASSEMBLY

Carefully check carton for signs of damage. Report
damages at once to carrier.

ATTACHING HANDLE TO BASE

1. Position the handle assembly on the base as
shown. Insert (4) screws, supplied, through the top
of the handle support and into the machine base.
From bottom side of base, secure screws with
nuts and washers (12 N–m / 8.85 ft–Lbs torque),
13 mm wrench required (Figure 1).
2. Connect the power cord into the switch housing
receptacle (Figure 1).
FIG. 1

ATTACHING OPTIONAL SOLUTION TANK

1. Attach the upper solution tank support bracket to
the handle as shown, do not tighten screws at this
time, 5 mm allen wrench required (Figure 2).
FIG. 2
2. Insert the tab at the bottom of the solution tank
into the tank support slot located near the handle
base as shown. Secure the top of the tank with
the upper support bracket as shown. Then tighten
the upper support bracket screws (Figure 3).
Tennant 2260/2270 (10–02)