Operating The Optional Solution Tank; Machine Maintenance - Tennant 2260 Manual Del Operador

FIG. 12
6. To move the machine left (A), slightly lower the
handle. To move right (B), slightly raise the
handle. Operate the machine with a side to side
motion (Figure 13).
A
FIG. 13
7. To stop machine, release the On/Off levers and
hold handles firmly until machine comes to a
complete stop. The safety lock lever will
automatically engage.
FOR SAFETY: When using machine, do not
release handles until pad comes to a complete
stop.
NOTE: The machine's circuit breaker may trip under
conditions of excessive overload. Change to a less
aggressive pad/brush and periodically check pad for
soil build–up. To reset circuit breaker switch, wait 15
seconds and press the reset button located on the
base switch housing.
8. Do not operate the machine in the same spot for a
long period of time. Floor damage may result.
9. To maneuver over thresholds and floor grates,
stop the machine and tilt it back on the transport
wheels.
10. When machine is not in use, do not leave machine
standing on the pad/brush. Pad/brush damage
may result.
11. When done scrubbing perform the following
machine maintenance procedures.
Tennant 2260/2270 (10–02)
B
Home Find... Go To..

OPERATING THE OPTIONAL SOLUTION TANK

1. Remove cover and fill the solution tank with a
recommended solution. Replace cover after filling.
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.
2. Lower handle to working position. Pull the solution
control lever to disperse solution to the pad/brush
(Figure 14).
WARNING: Do Not Use Flammable Liquids Or
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
This machine is not equipped with an explosion
proof motor. The electric motor will spark upon
start up and during operation which could cause a
flash fire or explosion if machine is used in an
area where flammable vapors/liquids or
combustible dusts are present.
FIG. 14

MACHINE MAINTENANCE

FOR SAFETY: When servicing machine, unplug
cord from wall outlet.
1. Remove and clean the pad driver/brush after each
use.
2. Clean the machine base after each use.
3. If equipped, rinse solution tank and solution supply
hose with clear water.
4. Inspect power cord for damage after each use. If
worn or damaged, replace immediately.
5. Wipe the power cord with damp cloth and neatly
coil it around cord hook and handle after each use.
6. Periodically check that all bolts and nuts are tight.
7. Every 250 hours of operation, check the motor for
carbon brush wear. Replace brushes when worn
to a length of 1 cm (3/8 in) or less. Contact an
Authorized Service Center for carbon brush
inspection.
FOR SAFETY: When servicing machine, all repairs
must be performed by a qualified service person.
OPERATION
13