After Use; Maintenance Schedule; Lubricating The Machine; Electromagnetic Brake - Clarke Focus II Rider Serie Instrucciones De Uso

A - ENGLISH

AFTER USE

1 When fi nished scrubbing, press the Scrub ON/OFF Switch (M), this will automatically raise, retract and stop all the machine systems (brush, squeegee,
vacuum, solution and detergent. Then drive the machine to a service area for daily maintenance and review of other needed service upkeep.
2 To empty the solution tank:
Remove the Solution Tank Drain Hose (2) from its storage clamp. Direct the hose to a designated "DISPOSAL SITE" and remove the cap. Rinse the tank
with clean water.
3 To empty the recovery tank, pull the Recovery Tank Drain Hose (28) from its storage area. Direct the hose to a designated "DISPOSAL SITE" and unscrew
the cap (hold the end of the hose above the water level in the tank to avoid sudden, uncontrolled fl ow of waste water). Inspect and empty the Strainer Basket
(26) in the recovery tank. Rinse the tank with clean water.
4 Remove the brushes or pad holders. Rinse the brushes or pads in warm water and hang up to dry.
5 Remove the squeegee and rinse it with warm water. Open the Recovery tank cover and hang the squeegee from the recovery tank using the Squeegee
Storage Hook (27).
6 Check the maintenance schedule below and perform any required maintenance before storage.
7 Store the machine indoors in a clean dry place. Keep from freezing. Leave the tanks open to air them out.
8 Turn the Key Switch (A) OFF (O) and remove the key.

MAINTENANCE SCHEDULE

Empty/Clean Strainer Basket in Recovery Tank
* Have an Authorized Clarke Service Center check the vacuum motor carbon motor brushes once a year or after 300 operating hours. The brush and drive motor
carbon brushes should be checked every 500 hours or once a year.
• Isolators are expected to last 250-1,000 hours depending on the application.
• Replace lower isolators annually or after every 250 hours, whichever comes fi rst.
LUBRICATING THE MACHINE - FIGURE 7
Grease fi tting locations (or apply grease to) (AA):
• Steering Chain
• Squeegee mount angle adjustment knob threads
• Side Skirt Height Adjustment Knobs
Once a month, apply light machine oil to lubricate the (BB):
• General Pivot Points For the Squeegee and Scrub Deck Linkage

ELECTROMAGNETIC BRAKE

See Figure 8. The Drive Wheel (4) has a built in electromagnetic brake
that is engaged whenever the Key Switch (A) is OFF or the Drive Pedal
(3) is in the neutral position. This brake can be manually overridden if
necessary by inserting a medium to large screwdriver behind the Yoke
(AA) as shown. This should only be done in the event you need to push
or pull the unit.
A - 14
INSTRUCTIONS FOR USE
MAINTENANCE ITEM
Charge Batteries
Check/Clean Tanks & Hoses
Check/Clean/Rotate the Brushes/Pads
Check/Clean the Squeegee
Check/Clean Vacuum Shut-Off Float
Check Each Battery Cell(s) Water Level
Inspect Scrub Housing Skirts
Inspect and clean Solution Filter
Purge Detergent System
Lubrication of Machine
* Check Carbon Brushes
Focus II Rider - 56091040
®
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
X
X
FIGURE 8
Yearly
X
7/12
5/12