En Proper Use - Collomix C-mix M1000 Manual De Servicio

EN Proper use

The machine is designed for mixing liquid and
powder-based building products such as paints,
mortar, adhesives, plaster and similar substances.
Use the right mixing tool for the consistency of the
material and the quantity to be mixed.
Please refer to the information in the technical data
when choosing the size of mixing tool (diameter/
mixing action). If the wrong mixing action or mixing
tool diameter is selected, this may cause the
machine/gear unit to become overloaded and lead
to damage as a result. Please remember that a
mixing tool with a mixing action from the top down
puts a greater strain on the electrical tool than one
with the reverse mixing action.
This electrical tool is not designed for use in
continuous operation.
Given the high torque levels generated by the
machine, it must not be used as a power drill.
The machine must not be used for the preparation
of foodstuffs.
The machine is not suitable for mixing materials
containing graphite dust, brine or slurry. Mixing of
these materials or substances may damage the
machine beyond repair.
Assembly
►Always pull the power plug out of the socket outlet
before carrying out any work on the machine.
Fitting the mixing tool mount:
Take the HEXAFIX coupling supplied with the
packaging and screw it to the male thread of the
mixing shaft.
Fitting the mixing tool / tool change-over:
HEXAFIX
Insert the mixing tool with the HEXAFIX mount in
the coupling until it locks. To release or change the
mixing tools, simply pull back the handle-collar on
the coupling and this releases the mixing tool.
Operation
►Check that the power supply shown on the rating
plate is the same as the mains power supply.
Always hold the machine with both hands.
Press the starting lockout button (1).
OFF switch fully pressed.
To stop working, release the ON/OFF switch.
Machines with 2-speed gear units (M1400) have
two maximum speeds available (First gear: Slow /
Second gear: Fast).
To change from one gear
to the other, turn the gear
selection lever through 180°.
Only ever actuate it when the
machine is at a standstill.
Always reduce the speed
when submerging the mixing
tool in the mixing material or
lifting it out. Once the mixing tool is fully submerged,
increase the speed again to ensure that the motor is
adequately cooled.
During mixing you should guide the machine around
the mixing container. Continue mixing until all of the
mixing material is completely mixed. Please follow
the processing instructions of the manufacturer of
the material.
The greater the viscosity of the material, the greater
the impact of the torque forces on the machine, so
you should be prepared for this when you carry out
your work.
If the mixing tool comes into contact with a surface
(e.g. the bottom of the tub) while running, it may kick
back.
Set the machine down resting on the guard handle
after you have finished your mixing work.
Press the ON/OFF switch
(2).
The more pressure
apply to the ON/OFF switch,
the faster the machine will
run. The ON/OFF switch
cannot be locked!
Always work with the ON/
you