BH HIPOWER SK Serie Instrucciones De Montaje Y Utilización página 11

10
. LEVELLING.-
Once the unit has been placed into its final location
for exercising, make sure that it sits flat on the floor
and that it is level.
This can be achieved by screwing the adjustable
support blocks (92) up or down, as shown in Fig.8.
11
. MOVEMENT & STORAGE.-
The machine is equipped with wheels (97) making
it east to move and store. Pull forward and down
on the handlebars until the wheels touch the
ground you can roll the machine easily. Fig.11
12.
PULSE MEASUREMENT.-
Your pulse rate is measured by placing both hands
on pulse sensors (110) located on the seat
handgrips or the handlebar, see Fig.12.
NOTE:
You can also use the chest band (OPTIONAL
TELEMETRIC PULSE SENSOR) to measure your
heart rate.
The reading from the telemetric pulse rate is
preferred over the pulse sensors (110) located on
the seat handgrips or handlebar.
13
. BATTERY CHARGE.-
Before plugging in the adaptor, make sure that the
outlet voltage is compatible with the AC/DC
adaptor.
Connect the AC/DC adaptor (L05) to the outlet.
Then, connect the DC terminal to the connector
located at the low end of the chain cover Fig.13.
BH RESERVES THE RIGHT TO MODIFY
THE SPECIFICATIONS
PRODUCTS WITHOUT PRIOR NOTICE.
11
SK
LINE
sportkoncept
OF ITS