DSR PRO Series Manual Del Usuario página 12

CODE
The charger shut off because
F07 its internal temperature exceeds
limit.
The battery voltage dropped too
low during the maintain mode.
F08
The Lithium Ion (LiFePO
F09
continues to read 0 V and is
therefore unable to be charged.
The voltage on the Lithium Ion
(LiFePO
F 10
safe limit.
If you get an error code, check the connections and settings and/or replace the battery.
Troubleshooting
PROBLEM
The battery is connected and
the charger is on, but is not
charging.
The indicator lights are lit
in an erratic manner, not
explained in the Operating
Instructions section.
The display shows,"BAD
BAT" and an error code.
The charger is making an
audible clicking sound.
The measured current is
much lower than expected.
While charging the battery,
the battery stays at a certain
% (ex. <65%).
When the charger is
unplugged or the settings
are changed, the number
increases or jumps to 100%.
DESCRIPTION
) battery
4
) battery exceeds the
4
POSSIBLE CAUSE
The charger is not in charger
mode.
A button may have been
pressed when the charger
was plugged in.
The charger was unable to
complete the charging of the
battery and is in abort mode.
See Error Codes for more
information.
The charger has a relay
that turns the current to the
battery on and off.
The charger reached the
maximum voltage and is
reducing the current.
The charger detected an
over-temperature condition
and has reduced the current
to allow the unit to cool.
The % display may not
change at a steady rate.
The battery voltage is still
high from a partial charge.
REASON/SOLUTION
Make sure the charger does not have the side
ventilation holes blocked. Move the charger out of
the sun and into the shade.
May be caused by a drain on the battery or the
battery could be bad. Make sure there are no loads
on the battery. If there are remove them. If there are
none, have the battery checked or replaced.
The Lithium Ion (LiFePO
Have it checked or replaced.
The charger automatically shuts off if it senses that
the Lithium Ion (LiFePO
the safe limit. The battery could be bad. Have it
checked or replaced.
• 12 •
) battery could be bad.
4
) battery voltage exceeds
4
SOLUTION
Press START/STOP button
for the battery that is
connected to the charger.
Make sure nothing is
touching the control panel,
then unplug the unit and plug
it in again.
Press the corresponding
START/STOP button, to turn
off and reset the charger.
No problem, this is a normal
condition.
No problem, this is a normal
condition.
Make sure the charger does
not have the side or rear
ventilation holes blocked.
Move the charger out of the
sun and into the shade.
DO NOT UNPLUG OR
CHANGE THE SETTING.
Be patient and let the charger
finish. This is normal.
Wait for the voltage to settle
before resuming the charge.
Turn on the lights to remove
the surface charge.