IMPORTANT SAFETY INFORMATION.
READ ALL INSTRUCTIONS BEFORE USING.
A WARNING:
If the water
heater has been
subJectedto flood, fire, or physical
damage, turn off power and water
to the water heater.
Do not operate the water heater
again until it has been thoroughly
checked by qualified service
personnel.
Safety Precautions
A. Do turn off power to water heater if
it has been subjected to overheating,
fire, flood or physical damage.
B. Do Not turn on water heater unless
it isfilled with water.
C. Do Not turn on water heater if cold
water supply shut-off valve is closed.
NOTE:Flammable vapors may be drawn
by air currents from surrounding areas
to the water heater.
D. If there is any difficulty in understanding
or following the Operating Instructions
or the Care and Cleaning section, it is
recommended that a qualified person
or serviceman perform the work.
Safety Controls
Thewater heater isequipped with a
temperature-limiting control (TCO) that
islocated above the heating element in
contact with the tank surface. If for any
reasonthe water temperature becomes
excessivelyhigh,the temperature-limiting
control (TCO) b reaks the power circuit to
the heating element. Oncethe control
opens, it must be reset manually. Resetting
of the temperature limiting controls should
be done by a qualified servicetechnician.
A CAUTION: The cause
of the high temperature condition must
be investigated by a qualified service
technician and corrective action must
be taken before placing the water heater
in service again.
To reset the temperature-limiting
control:
1. Turn off the power to the water
heater.
2. Remove the jacket access panel(s)
and insulation.
The thermostat protective cover
should not be removed.
3. Press the red RESET button.
4. Replace the insulation
and jacket
access panel(s) before turning
on
the power to the water heater.
4
SAVE THESEINSTRUCTIONS