Troubleshooting - Argo LILIUM 11 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

TROUBLESHOOTING

PROBLEM
The dehumidifier is not working.
It is not possible to adjust the settings.
The noise suddenly increases while
running
Condensation is not collected in the
tank
Reduced dehumidification effect
At first, the air might have a musty
smell
There is water in the tank even when
using the hose for continuous
condensation drainage
The ON/OFF LED does not turn on
when the power is connected
The dehumidifier stops working during
dehumidifying process.
The clothing can't be dry fast.
The dehumidifier stops intermittently
during the operation.
The humidity of the room can't reduce.
Unpleasant smell.
The machine unit makes a sound
during operation.
There is water in the tank.
V 06/17
POTENTIAL CAUSE
The temperature is above 32 ° C or below 5
°C.
The internal tank is full.
The tank is not positioned correctly.
The set humidity level is higher than that in the
room.
The compressor has just started.
There is a power connection problem.
The unit is placed on an uneven surface.
The room is too big for the unit's capacity.
The doors are open.
There are other devices producing moisture in
the room.
The room temperature is too low.
The set humidity level is inadequate.
The filter is full of dust.
The doors and windows are open.
If the unit is running with a temperature
between 5 and 15 °C, the unit will pause for
automatic defrosting. The compressor will
pause for short periods. After the defrost, the
unit will resume normal operation.
Due to the temperature difference of the heat
exchanger, the air might have a strange smell
at first.
Check the drainage connections.
The drainage hose is not connected properly.
There is no power or the plug is not inserted
correctly.
Whether the room temperature is too high or
too low and out of the working scope of the
dehumidifier.
Whether the room temperature is very low.
The defrosting.
The room area is too big, which is over its
application scope.
The door and windows of the room aren't
closed.
The machine unit is operated with a kerosene
heater which releases steam.
The smell may come from the wall, furniture
and other things.
The sound made by the flowing of the
refrigerant may eliminate or lower
automatically while the system operates
stably.
Since each machine unit has taken operation
SOLUTION
Empty the tank
Position the tank correctly
Reduce the humidity level.
Clean the filter.
Close any doors and windows.
Connect the hose correctly.
Remove the drainage hose and
replace it.
Check the electrical power supply.
Make sure that the electric circuit
and plug are not damaged.
Make sure that the cable is not
damaged.
The dehumidifier may start
automatically when the room
temperature returns to the working
scope.
The wet clothing may dry more
slowly in low temperature.
22

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Lilium 13

Tabla de contenido