Bridge Connections - Yamaha M-5000 Manual De Instrucciones

R channel
R channel
High
Low
Shorting bar
In a bridge connection configuration, the M-5000 is used
as a monaural amplifier. To create a stereo system, you
need two M-5000 units.
On each amplifier, connect the "+" terminal of the
SPEAKERS L CH to the "−" terminal of the SPEAKERS
R CH. For this connection, use a cable that features the
same material as the speaker cables, and a length of 1.0 m
or less and a cross-sectional area of 1.0 mm
not bundle the cable.
Connect the input source to the L-channel input jacks on
both M-5000 units.
22

Bridge connections

B
MODE: DUAL MONO/BRIDGE
or larger. Do
2
Preamplifier
R channel
R channel signal
MODE selector
NOTICE
Since amplification will be doubled in this configuration,
adjust the volume level appropriately on the connected
preamplifier . If you are using a Yamaha preamplifier that
features a GAIN selector, adjust the volume level using this
selector so that you will be able to use volume controls on
other components in the usual way .
1
Turn off the power to the unit and all
connected components
2
Set the MODE selector on the rear panel to
DUAL MONO/BRIDGE
L channel
L channel signal
M-5000
B
SPEAKERS selector
(front panel)
SPEAKERS
A
OFF B
+
A B
BI WIRING
B
MODE: DUAL