Memory Card - Nice BIO Serie Manual De Instrucciones

COUPLING RECEIVERS:
Coupling receivers are provided to be directly coupled to NICE "A" series units. Once coupled, they are
ready for operation, since all electric signals (power supply, antenna and outputs) go to their respective
points in the unit.
Fig. 3
POWER SUPPLY:
12 to 24 V DC or AC with
usually supplied by the unit.
1st RELAY OUTPUT:
Clean contact of normally open
relay, used for unit control.
2nd RELAY OUTPUT:
Clean contact of normally open
relay, available on special unit
terminals (only for twin channel
receivers).
ANTENNA: Antenna signal input, fitted on special unit terminals.
BXIK 1 CHANNEL
BXI2K 2 CHANNELS
- 26 -

MEMORY CARD

Receivers are supplied with a BM60 memory card that can contain up to 60 codes (max. limit
of 60 remote controlled codes). A memory card with 250 codes (BM250) can be optionally supplied and
must be fitted to replace the BM60 card supplied. The receiver automatically recognizes the type of card
inserted.
When maximum safety is required, the code learning function must be disabled (also considering the fact
that it may be remote-controlled). After entering the codes from the remote controls concerned, just cut
the arrow indicated by an arrow (Fig. 4).
If you wish to enter other codes at a later date, join the two contacts with a drop of tin (Fig. 5).
NB: The memory card is enabled and disabled with receiver off.
Fig. 4 Fig. 5
- 27 -
GB