Nice BIO Serie Manual De Instrucciones página 19

- Press any button on the NEW transmitter to send the NEW code for at least 5 sec.
!
Now slowly but positively;
- Press any button on the OLD transmitter three times to send the OLD code three times;
- Press any button on the NEW transmitter to send the NEW code once for confirmation.
The operation has now been completed and can be repeated immediately with a new remote control.
NB: This operation enters the new code in all receivers locating within the operating range that
recognize the old code (and which are not disabled). Therefore, if there are several receivers
nearby with the old code previously entered, switch off those not involved in the operation.
DELETING A CODE
This operation lets you remove a code from the receiver's memory.
The operations are timed and you thus need to read all the instructions to perform the operation in
sequence without stopping.
- 36 -
- Keep the button on the receiver pressed (approx. 3 sec.) and then the LED
will switch off, then release the key.
- Press any button on the transmitter to transmit the code until the LED goes off
!
again.
Release the transmitter key and wait 1 sec.
- Press any key on the transmitter to send the code for confirmation.
The LED will flash once to indicate that the code has been deleted. If this does not occur, repeat the entire
operation from scratch.
DELETING ALL CODES
This operation lets you remove all codes stored in memory (which is reset empty). The 2nd learning lock
is also removed and the TIMER is reset to default time of 3 sec. (only for special version).
The operations are timed and you thus need to read all the instructions to perform the operation in
sequence without stopping.
- Keep the button on the receiver pressed and after 3 sec. the LED will switch off;
- Release the key during the 3rd following flash.
!
- Wait about 3 sec.
- Press the key as soon as the LED lights up again and release it as soon as it switches
off.
- 37 -
GB