Tabla de contenido
Publicidad
1. Introduction
AMI is specially designed for titrations, and particularly for those in which optimum lighting condition are needed in order to
see the final point of colour change well. This magnetic stirrer is illuminated.
The lighted stirrer plate is particularly recommended for titrations that have weak colour changes during conversion. By the
switch it's possible turn on the lighted stirrer plate. The stirrer stay cold even after several days of continuous use. This
feature makes it highly appreciated in microbiology and biochemistry.
NOTE: it is advisable to choose the most suitable magnetic stir bar in relation to the quantity and characteristics of the liquid
and the type of vessel used. The stirring bar which satisfies most application is code A00001056 (6x35mm).
2. Assembly and installation
Upon receipt and after having removed the packaging, please check the integrity of the instrument. The box includes:
• Magnetic stirrer AMI
2.1 Electrical connection
After having unpacked the instrument, place the unit on the laboratory bench.
Before connecting the instrument to the power supply, make sure that the values on the rating plate correspond to those of
the power supply. Connect the unit to the power supply using the transformer supplied.
Ensure that the socket and the relative cut-off device conform to current safety norms and easy to reach.
2.2 Start-up
Rotate the speed knob completely to the left. Place the flask containing the sample and a suitable magnetic stirring bar on
the stirring plate. Then, set the speed by turning the speed knob.
3. Operating controls
Turn the stirring speed knob on the front panel in order to start the stirring function. The Stirrer Led shows when the stirring
is running. The instrument is equipped with a hole in the bottom through which it's possible to modify the illumination
brightness using a flat screw driver.
4. Maintenance
No routine or extraordinary maintenance is necessary apart from periodically cleaning the unit as described in this manual.
In compliance with the product guarantee law, repairs to our units must be carried out in our factory, unless previously
agreed otherwise with local distributors. The instrument must be transported in its original packaging and any indications
present on the original packaging must be followed (e.g. palletized).
It is the responsibility of the user, to properly decontaminate the unit in case of hazardous substances remaining on the
surface or interior of the device. If in doubt about the compatibility of a cleaning or decontamination product, contact the
manufacturer or distributor.
4.1 Cleaning
Disconnect the unit from the power supply and use a cloth dampened with an non-inflammable non-aggressive detergent.
• Switching power supply 100-
240 V/12 V
7
• Instruction manual
EN
Publicidad
Tabla de contenido
