Introduction; Assembly And Installation - Velp Scientifica AREX-6 CONNECT PRO Manual De Instrucciones

1. Introduction

The AREX-6 Connect PRO heating magnetic stirrer is used in the laboratory for general use and for all those applications that require a
precise regulation for stirring speed and heating liquids.
The integrated Wi-Fi module transmits and receives information in order to allow the equipment monitoring and control through VELP
Ermes platform.
B
1 Aluminum alloy plate with ceramic coating
2 Main switch
3 Speed control knob
4 Temperature control knob
5 Display
The Aluminum alloy heating plate with ceramic coating (1)
• Optimum heat distribution and a high specific power thanks to the circular configuration
• Temperature homogeneity
• High resistance to thermal stress and thermal shock
• High resistance to chemical agents and surface abrasion
Magnetic stirring is generated by an AlNiCo magnet, driven by brushless motor which offers a virtually unlimited duration.
Size and shape of the magnetic stir bar determines the stirring efficiency at any given speed.
The stirring bar code which satisfies most applications is
NOTE: The vessel must be made of a suitable material to withstand the foreseen temperature.
NOTE: Using the heating plate at high temperatures may cause discoloring. This does not alter the thermal, mechanical and chemical
resistance of the plate in any way.

2. Assembly and installation

•
Unpacking
- Check the integrity of the unit after unpacking.
•
The box includes
- AREX-6 Connect/Connect PRO heating magnetic stirrer
- Power supply cord
- Instruction manual
•
First installation
- Place the unit on not-flammable surface
- Make sure that the values on the rating plate, correspond to those of the power supply
- Move the main switch (2) to the OFF position
- Ensure that the socket provided with grounding is accordant to current safety norms and easy to reach. Use only the cable
provided with the instrument.
- Insert the mains power cable into the socket
NOTE: the mains cable must remain far away from the hot plate. It can be substituted only by main cables with same features (T=90°C,
connector C15).
5
4
A
C
Ø8x40mm
G
A Probe led
B Heating ON led
C Temperature set point led
D Timer led
E Wi-Fi led
F Autoreverse led
G Timer/autoreverse/lock button
.
5
1
3
2
D
E
2
F
F
ensures:
EN