Cautions On Use; Place Of Installation; Do Not Place Objects On This Unit; Cleaning The Product - Pioneer X-EM26 Manual De Instrucciones

 Clock/timer setting is erased.
 Power has been interrupted or the AC power cord has
been disconnected.
 Reset the clock/timer.
When the Bluetooth wireless technology device is
connected or operated (X-EM26 only)
 The Bluetooth wireless technology device cannot be
connected or operated.
Sound from the Bluetooth wireless technology device
is not emitted or the sound is interrupted.
 Check that no object that emits electromagnetic
waves in the 2.4 GHz band (microwave oven, wireless
LAN device or Bluetooth wireless technology
apparatus) is near the unit. If such an object is near
the unit, set the unit far from it. Or, stop using the
object emitting the electromagnetic waves.
 Check that the Bluetooth wireless technology device
is not too far from the unit and that obstructions are
not set between the Bluetooth wireless technology
device and the unit. Set the Bluetooth wireless
technology device and the unit so that the distance
between them is less than about 10 m* and no
obstructions exist between them.
* The distance given is to be used as a rough guide. The
actual allowable distance between devices may vary
depending on conditions in the surrounding environment.
 The Bluetooth wireless technology device may not be
set to the communication mode supporting the
Bluetooth wireless technology. Check the setting of
the Bluetooth wireless technology device.

Cautions on use

∫ When moving this unit
When moving this unit, be sure to first check that there is no
disc loaded. Then press Í, wait until [STANDBY]
disappears on main display to turn off, and then unplug the
power cord. Damage may occur if the unit is transported or
moved with a disc inserted, or when another device is
connected to the USB terminal, or AUDIO IN mini-plug jack.

∫ Place of installation

• Choose a stable place near the TV or stereo system
being used with this unit.
• Do not place this unit on top of a TV or color monitor.
Also, install it away from cassette decks and other
devices easily affected by magnetic forces.
Avoid the following locations:
• Places exposed to direct sunlight
• Humid or poorly ventilated places
• Extremely hot places
• Places exposed to vibrations
• Places in which there is much dust or cigarette smoke
• Places exposed to soot, steam, or heat (kitchens, etc.)

∫ Do not place objects on this unit

Do not place any objects on top of this unit.
Do not obstruct the ventilation holes.
Do not use this unit on shaggy rugs, beds, sofas, etc., or
wrapped in cloth, etc. Doing so will prevent the heat from
dispersing, leading to damage.
Do not expose to heat.
Do not place this unit on top of an amplifier or other
components that generate heat. When rack mounting it, to
avoid the heat given off by the amplifier or other audio
components, place it on a shelf below the amplifier.
16
En
• Turn off the power of this unit when not using it.
• Depending on signal conditions, striped patterns may
appear on a TV screen and noise may enter the sound
of radio broadcasts when the power of this unit is on. If
this happens, turn off the power of this unit.

∫ Cleaning the product

• Unplug the power cord from the power outlet when
cleaning this unit.
• Clean this unit using a soft cloth. For tough dirt, apply
some neutral detergent diluted in 5 to 6 parts water to a
soft cloth, wring out thoroughly, wipe off the dirt, and
then wipe again with a soft, dry cloth.
• Alcohol, thinner, benzene, insecticides, etc., could
cause the print or paint to peel off. Also, leaving rubber
or vinyl products in contact with this unit for long periods
of time could mar the cabinet.
• When using chemical-impregnated wipes, etc., read the
cautions included with the wipes carefully.

∫ Cleaning the lens

• The lens of this unit should not become dirty in normal
use, but if for some reason it should malfunction due to
dust or dirt, consult your nearest Pioneer authorized
service center. Although lens cleaners for players are
commercially available, we advise against using them
since some may damage the lens.

Handling discs

∫ Storing
• Always place discs in their cases and store them
vertically, avoiding hot, humid places, places exposed
to direct sunlight and extremely cold places.
• Be sure to read the cautions included with the disc.

∫ Cleaning discs

• Discs may not play if there are fingerprints or dust on
them. In this case, use a cleaning cloth, etc., to gently
wipe the disc from the inside towards the outside. Do
not use dirty cleaning cloths.
• Do not use benzene, thinner or other volatile chemicals.
Also, do not use record spray or antistatic agents.
• For tough dirt, apply some water to a soft cloth, wring
out thoroughly, wipe off the dirt, and then wipe off the
moisture with a dry cloth.
• Do not use damaged (cracked or warped) discs.
• Do not let the signal surface of discs get scratched or dirty.
• Do not attach pieces of paper or stickers to discs. Doing
so could warp discs, making it impossible to play them.
Also, note that rental discs often have labels attached to
them, and the glue of the label may have oozed out.
Check that there is no glue around the edges of such
labels before using rented discs.