Fagor 670040240 Manual Del Usuario página 10

To press a button, you have to apply a fi rm tap with your fi nger. Hold out your index
fi nger horizontally, about one inch above the button you are trying to tap, and then tap
quickly and fi rmly, lifting your fi nger once done (see image below).
The buttons will not react if you:
• use the very tip of your fi nger or your fi ngernails (see image below)
• slide your fi nger over it without tapping
• press it too gently
• tap outside the area of the button, delimited by the white squares
How to use your Fagor Induction Cooktop:
1. Follow the instructions for proper installation of the cooktop, found in this manual.
Plug the power cable into a properly installed outlet.
2. Tap the ON/OFF button once.
The cooktop will turn on and remain in standby mode. The light beside the
ON/OFF button will blink and the symbol –:-- will appear on the display panel. If
you do not press any other buttons in the next 2 minutes, the cooktop will beep
once and turn itself off.
3. Place the pot or pan you are going to use in the middle of the cooking zone. Tap
the START button once. The cooktop turns on to the default power level 4 and
the light beside the START button turns on. The -:-- symbol will turn into a 4 to
indicate that you are cooking on power level 4. You will hear the fan as it starts to
function.
If you tap the START button before placing induction compatible cookware on the
cooktop, it will beep continuously to indicate that it doesn't detect any cookware
and cannot generate heat. After 60 seconds the cooktop will turn itself off.
4. Once you have tapped the START button and have started cooking on the
default level "4", you can increase or decrease the power by tapping the
PLUS / MINUS buttons. The power levels range from 1 to 6:
PIC Manual Revision.indd 8 PIC Manual Revision.indd 8
8
5/16/09 6:22 PM 5/16/09 6:22 PM