Vermeiren Antares 3 Manual De Instrucciones página 23

7.7 ASSEMBLING THE SCOOTER
 Suggestion
The assembly process is essentially the disassembly process in reverse. First study the
text and photographs in the disassembly procedure before re-assembling the scooter.
7 . I N S P E C T I O N A N D M A I N T E N A N C E
1. Position the front and rear sections of Antares
2. Align the lower curved locking brackets of the front section with
the corresponding pegs on the front of the rear section.
3. Plug in electrical connector to connect the front and rear sections.
4. Holding the lower seat post, slowly pivot the rear section forward until
the curved locking brackets are fully connected on to the top rear pegs.
5. Loosen tiller adjustment knob, raise the tiller to the desired position, and then tighten
the tiller adjustment knob.
6. Reinstall the upper seat post at the desired height. Secure with the locking pin and
tighten the seat post knob.
7. Reinstall the batteries by lowering it in to place.
8. Replace the seat and rotate it until it locks into its correct position.
 Warning
After assembling the Antares, make absolutely certain the tiller adjustment knob is fully
tightened.
Knob lock
23