10.6 Starting a programme
without the delay start
Press button Inicio/Pausa to start the
programme.
The relevant indicator stops to flash and
stays on.
On the display the indicator of the phase
is operation starts to flash.
The programme starts, the door is
locked. The display show the indicator
.
The drain pump can operate
for a short time when the
appliance fills water.
10.7 Behaviour of the
appliance
After approximately 15
minutes from the start of the
programme:
• The appliance adjusts
automatically the cycle
time to the laundry you
have put in the drum to
have perfect washing
results in the minimum
necessary time.
• The display shows the
new time value.
10.8 Starting a programme
with the delay start
1. Press button Inicio Diferido again
and again until the display shows the
number of minutes or hours of delay.
The related indicator comes on.
2. Press button Inicio/Pausa.
The appliance starts the countdown of
the delay start.
When the countdown is completed, the
programme starts automatically.
Before you press button
Inicio/Pausa to start the
appliance, you can cancel or
change the set of the delay
start.
10.9 Cancelling the delay start
To cancel the delay start:
1. Press button Inicio/Pausa to set the
appliance to pause.
The related indicator flashes.
2. Press button Inicio Diferido
repeatedly until the display shows .
3. Press button Inicio/Pausa again to
start the programme immediately.
10.10 Interrupting a
programme and changing a
function
You can change only some options
before they operate.
1. Press button Inicio/Pausa.
The related indicator flashes.
2. Change the function set.
3. Press the button Inicio/Pausa again.
The programme continues.
10.11 Cancelling a running
programme
1. Press button On/Off to cancel the
programme and to deactivate the
appliance.
2. Press button On/Off again to activate
the appliance.
Now, you can set a new washing
programme.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
10.12 Opening the door
If the temperature and level
of the water in the drum are
too high and the drum still
rotates you cannot open the
door.
While a programme or the delay start
operates, the appliance door is locked.
1. Press button Inicio/Pausa.
In the display the related door lock
indicator goes off.
2. Open the appliance door.
3. Close the door and press button
Inicio/Pausa.
ENGLISH
19