Operation; Location And Function Of Controls - Sony XM-GS6DSP Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation

Location and Function of Controls

Control panel side
Connector panel side
 POWER/PROTECTOR indicator (green)
– Lights up when the unit is turned on.
– Flashes when the unit detects an abnormality.
See "Troubleshooting" (page 21) for solutions
to problems.
PAIRING button
Press and hold for 2 seconds to enter the pairing
standby mode.
Press and hold for 7 seconds to turn off the
BLUETOOTH functions (BLUETOOTH off mode).
(Available only when the SELECT switch is set to
the "2V" or "5V" position.)
(BLUETOOTH) indicator (blue)
– Flashes quickly in pairing standby mode.
– Flashes slowly in BLUETOOTH standby mode.
– Lights up when BLUETOOTH connection is
established.
 RESET button
Resets the unit to the factory defaults (the DSP
settings and BLUETOOTH pairing information
stored on the unit are also erased).
Press with a pointed object such as a ballpoint
pen.
 SELECT (input select) switch
Selects "2ch/BT" or "6ch" mode depending on
the use/non-use of the DSP. When selecting the
"2ch/BT" mode, also select the sensitivity "2V"
or "5V" depending on the pre-output level of
your car audio unit (page 10).
TWEETER/FRONT (tweeter/front speaker)
section:
 HIGH PASS FILTER switch
Turns the high-pass filter on/off.
 HIGH PASS FILTER control
Adjusts the cut-off frequency (500 Hz – 4 kHz).
 LEVEL control
Adjusts the input level (0.3 V – 6 V). Turn it
clockwise when the output level of the audio
device seems low.
5
GB

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido