Installation; Mounting The Unit; Connections - Sony XM-GS6DSP Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation

 Select the mounting location where it is easy to
press the PAIRING button on the unit.
 Choose the mounting location carefully so the
unit will not interfere with the normal movements
of the driver and it will not be exposed to direct
sunlight or hot air from the heater.
 Do not mount the unit in a confined space such as
under the floor carpet that will obstruct heat
dissipation.

Mounting the unit

First, place the unit where you plan to install it, and
mark the positions of the 4 screw holes on a
mounting board (not supplied). Then drill a 3 mm
(
1
/
in) pilot hole at each mark and mount the unit
8
onto the board with the supplied mounting screws.
The mounting screws are all 20 mm (
so make sure that the mounting board is thicker
than 20 mm (
13
/
in).
16

Connections

 Before making any connections, disconnect the
 Be sure to use speakers with an adequate power
 Do not connect the  terminal of the speaker
 Install the input and output cords away from the
 This unit is a high powered amplifier. Therefore, it
 If your car is equipped with a computer system for
13
/
in) long,
16
Making the terminal connections
Pass the wires through the cap, connect the wires,
then cover the terminals with the cap.
Note
When you tighten a screw, be careful not to apply too
much torque as doing so may damage the screw (the
torque value should be less than 1 N•m).
ground (earth) terminal of the car battery to avoid
short circuits.
rating. If you use small capacity speakers, they
may be damaged.
system to the car chassis, and do not connect the
 terminal of the right speaker with that of the
left speaker.
power supply wire. Running them close together
may generate interference noise.
may not perform to its full potential if used with
the speaker cords supplied with the car.
navigation or some other purpose, do not remove
the ground (earth) wire from the car battery. If you
disconnect the wire, the computer memory may
be erased. To avoid short circuits when making
connections, disconnect the +12 V power supply
wire until all the other wires have been
connected.
7
GB

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido