Other Features; Set The Alarm Timer - Philips DC390/12 Manual Del Usuario

6 Other features

Set the alarm timer

You can set two alarms which go off at different
time.
1
Make sure that you have set the clock
correctly. (See "Get started - Set time
and date".)
2
Press and hold ALM 1 or ALM 2 for two
seconds.
» [AL 1] or [AL 2] begin to blink.
3
Press SOURCE on the top panel to select
an alarm sound source: DOCK1, DOCK2,
FM tuner, or buzzer.
4
Press ALM 1 or ALM 2.
» The hour digits begin to blink.
5
Press / repeatedly to set the hour.
6
Press ALM 1 or ALM 2 to confirm.
» The minute digits begin to blink.
7
Repeat steps 5-6 to set the minute.
8
Repeat steps 5-6 to select whether to
ring alarm the whole week, on weekdays,
or at weekend.
9
Repeat steps 5-6 to set the alarm volume.
Tip
•
You can create a playlist in iTunes called
"PHILIPS" and import it to your iPod/iPhone
as alarm source.
•
If no playlist is created in the iPod/iPhone or
there is no song in the playlist, the unit will
wake to songs in the iPod/iPhone.
Activate and deactivate the alarm
timer
1
Press ALM 1 or ALM 2 repeatedly to
activate or deactivate the timer.
» If the timer is activated, [
[ AL2] is displayed.
Repeat alarm
1
•
You can press / to adjust the interval to
repeat alarm.
Stop alarm ring
1
View the alarm settings
1
Adjust display brightness
1
AL 1] or
» If the timer is deactivated, [ AL1] or [
AL2] is displayed.
When the alarm rings, press
BRIGHTNESS/REP ALM.
» The alarm repeats ringing minutes later.
Tip
When the alarm rings, press the
corresponding ALM 1 or ALM 2.
» The alarm stops but the alarm settings
remain.
Press ALM 1 or ALM 2.
Press BRIGHTNESS/REP ALM
repeatedly to select different levels of
display brightness.
EN
15