Automatic Power-Switching Function; Changing The Auto Standby Setting - Yamaha NS-SW700 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

AUTOMATIC POWER-SWITCHING FUNCTION

This function automatically switches the unit between standby and power-on mode.
The subwoofer automatically places itself in standby mode if it does not receive an input signal for 7 or 8 minutes. (The
power indicator lights red.)
When the subwoofer detects a bass signal input of below 200 Hz, it automatically places itself in power-on mode. (The
power indicator lights green.)
Notes
• This function is available only when the POWER switch and STANDBY/ON button are set to ON.
• Noise received from other appliances may extend the time period before the subwoofer places itself in standby
mode to more than 8 minutes.
1
Set the subwoofer to standby.
2
Change the AUTO STANDBY setting.
- LOW: Select this position to activate this function.
- HIGH: If this function does not operate with AUTO STANDBY switch set to LOW, select this position so that the
subwoofer detects input signals with a lower level and switches the power on automatically.
- OFF: Select this position to deactivate this function, for example, when the subwoofer switches the power on
unexpectedly by sensing noises from other appliances.

Changing the AUTO STANDBY setting

11
En

Publicidad

Tabla de contenido
loading

Tabla de contenido