Listening To Music; Bluetooth.connecting; Playing.back - Sony WALKMAN WLA-NWB1 Manual De Instrucciones

Listening to music

Bluetooth Connecting / Playing back
You can listen to music of the Walkman connected to this unit on the
Bluetooth receiving device (headset, etc.).
Before starting operation, complete pairing this unit and the
Bluetooth receiving device (page 8).
1
Set the Bluetooth receiving device to "Connectable" for the
Bluetooth connection.
the Bluetooth receiving device.)
2
Connect this unit to the Walkman then turn on the Walkman.
This unit's indicator status will vary as follows, and the Bluetooth
connection between this unit and the Bluetooth receiving device
is established.
Indicator flashes twice: Power is on
Indicator flashes (at about 1-second intervals): Connecting in process
Indicator flashes twice: Connecting successful
Indicator flashes slowly (at about 5-second intervals): Connecting
If the Bluetooth connection is not established within 5 minutes,
this unit automatically turns itself off. In this case, turn it on
again by pressing and holding the power button for about 2
seconds.
Note
If you want to establish the Bluetooth connection with a Bluetooth device that
is paired before either of the last two devices recognized, turn on the unit and
establish the Bluetooth connection from the Bluetooth device while the unit's
indicator flashes slowly from 10 to 13 times (for about 10-13 seconds). If the
problem persists, pair the devices again.
(See the operating instructions supplied with




Continued
11
GB