Bosch GLM 50 C Instrucciones De Funcionamiento página 12

is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connect-
ed.
• Consult the dealer or an experienced radio/TV
technician for help.
"This device has been designed to operate with the
antennas listed below, and having a maximum gain of
0.9 dB. Antennas not included in this list or having a
gain greater than 0.9 dB are strictly prohibited for use
with this device. The required antenna impedance is
50 ohms."
"To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is
not more than that permitted for successful commu-
nication."
"Exposure to Radio Frequency (RF) Signals: The wire-
less device is a radio transmitter and receiver. It is
designed and manufactured not to exceed the emis-
sion limit for exposure to radio frequency (RF) energy
set by the Ministry of Health (Canada), Safety Code
6. These limits are part of comprehensive guidelines
and established permitted levels of RF energy for the
general population.
These guidelines are based on the safety standards
previously set by international standard bodies. These
standards include a substantial safety margin de-
signed to assure the safety of all persons, regardless
of age and health.
-12-