Fagor 8H-885ADTFTN Manual De Instrucciones página 51

OPERATION
WiFi function
The oven is equipped with the WiFi function. It
can be controlled by mobile application.
Note:
• Touch each time to confirm your selec-
tion, or touch
• When you activate the function, the WiFi
menu will be displayed.
• No operation for 30 seconds, the appli-
ance enters Standby mode.
• To immediately exit from the menu and
switch the appliance to standby mode
touch and
To access the WiFi menu in standby mode,
touch and hold the
sensors select one of the following:
- WIFI,
- PARING,
- MONITOR,
- CONTROL,
- RESET,
- ERROR.
Touch to make your selection and then
touch to confirm. Then select ON/OFF or
YES/NO to RESET. Touch
Note: By default the WiFi feature is OFF.
Available connection modes:
• Access Point — connect your mobile de-
vice directly to the oven without the use
of any home wireless network devices.
• LAN — connect your mobile device to
the oven via the home WiFi network,
access from outside this network is not
possible.
• WAN — connect your mobile device to
the oven via the Internet – the appliance
can be accessed from anywhere in the
world.
Note: Active connection is indicated on the
display. Access Point is the default connection.
to adjust the settings.
.
sensor. Then touch the
to confirm.
You can change the connection type using
the mobile app.
Please visit www.fagorelectrodomestico.
com for step-by-step instructions how to
configure your network.
Error Codes: When there is a connection fail-
ure, you can check the error code in ERRORS
or WiFi menu:
Error Reason
Connection
E20
error
Number
E21 of users
exceeded
Information you need for correct configuration:
• Make sure that the oven is connected to
the power supply.
• In Access Point mode, make sure you
are within range (SSID: SmartIN).
• In LAN mode, make sure that your mo-
bile device is connected to the same
WiFi home network that the oven is con-
nected to.
• In WAN mode, make sure the Internet
connection is available in your WiFi net-
work.
• In LAN and WAN mode, you will need
a password (if exist) to connect to your
home WiFi network.
Solution
Try to reconnect
and, if unsuccessful,
contact your net-
work administrator
The appliance
stores all users
who connect by
Wifi - to erase the
list, disconnect the
appliance from the
power supply and
reconnect again.
51