Measuring Resistance - Surtek 111001 Manual De Usuario

The measured value shows on the display.
Note:
• If the value of current to be measured is
unknown, use the maximum measurement
position (10A) and reduce the range step by step
until a satisfactory reading is obtained.
• When current measurement has been completed,
disconnect the connection between the testing
leads and the circuit under test.
D.

Measuring Resistance

(Figure 4)
Warning
To avoid damages to the Meter or to the
devices under test, disconnect circuit
power and discharge all the high-voltage
capacitors before measuring resistance.
The resistance measurement positions are: 200Ω,
2000Ω, 20kΩ, 200kΩ and 20MΩ.
To measure resistance, connect the Meter as
follows:
1. Insert the red test lead into the VΩmA terminal
and the black test lead into the COM terminal.
2. Set the rotary switch to an
appropriate measurement
position in Ω range.
3. Connect the
test leads across
with the object
being measured.
The measured
value shows on
the display.
Figure 4
E N G L I S H
33