Battery Test - Surtek 111001 Manual De Usuario

E N G L I S H
F.

Battery Test

(Figure 5)
To avoid harms to you or damages to the
Meter, please do not attempt to input
voltages higher than 60V in DC or 30V
To test the battery, proceed as follows:
1. Insert the red test into the VΩmA terminal and
the black test leads into the COM terminal.
2. Set the rotary switch to an appropriate
measurement position in
3. Connect the test leads across with the battery
being measured ensuring the polarity is correct.
The measured value shows on the display, which
is the voltage between the cathode and anode of
the battery.
36
Warning
in AC.
range.
Note:
• When battery testing has been completed,
disconnect the testing leads and the circuit
under test.
Figure 6