Controls And Displays; Explanation Of Warning Symbols And Notes; Safety Instructions; Package Contents - Hama INSOMNIA COAL Instrucciones De Uso

G Operating instruction

Controls and Displays

1. Headset
2. Mute switch
3. Volume control
4. 3.5 mm connector
Thank you for choosing a Hama product.
Take your time and read the following instructions
and information completely. Keep these operating
instructions in a safe place for future reference.

1. Explanation of Warning Symbols and Notes

Warning
This symbol is used to indicate safety instructions or
to draw your attention to specific hazards and risks.
Note
This is used to indicate additional information or
important notes.

2. Package Contents

• Insomnia Coal headset
• Operating instructions
6

3. Safety Instructions

• This product is intended for private, non-commercial
use only.
• Only use the product for the intended purpose.
• Protect the product from dirt, moisture and
overheating, and only use it in dry locations.
• Do not drop the product and do not expose it to any
major shocks.
• Keep this product, as all electrical products, out of the
reach of children!
• Dispose of packaging material immediately according
to locally applicable regulations.
• Do not open the device or continue to operate it if it
becomes damaged.
• Do not modify the device in any way. Doing so voids
the warranty.
Warning
Always keep the volume at a reasonable level. Loud
volumes, even over short periods, can cause hearing
loss.

4. Getting Started

• Turn down the volume of your headset using the
volume control (3) integrated into the cable control.
• Deactivate the mute function of your microphone
by pushing the slide control (2) to position "B" (see
figure).
• Only now should you connect the 3.5 mm connector
(4) on the headset to the 3.5 mm port on your
controller.
• Adjust the volume of your headset as desired.
• You can optionally slide the mute switch (2) on the
cable control to position (A) to the mute position.
• You can optionally slide the mute switch (2) back to
position (B) to switch on the microphone again later.
• If your Xbox One controller does not have a 3.5
mm port, connect your Microsoft Xbox One headset
adapter (not included) to a controller that is connected
to the Xbox One.