Adjusting The Stability And The Maneuverability; Maintenance - Vermeiren Eclips X4 kids 90 Manual De Instrucciones

3.12 Adjusting the stability and the maneuverability

L
WARNING:
Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
L
Risk of injury - Make sure that the axle adapters  of the rear
WARNING:
wheels on both sides are mounted in the same position.
L
WARNING:
Risk of tipping over - Be aware that you change the stability of the
wheelchair.
Standard shall be an anti-tipping device mounted on the wheelchair when the axle adapter 
is positioned to the front.
Some of the wheelchairs are made with an adjustable axle adjuster. With these adjuster you
can also change the stability and the manoeuvrability of your wheelchair.
1
4

Maintenance

For the maintenance manual of the manual wheelchairs refer to the Vermeiren website:
www.vermeiren.be.
The driving wheels are mounted in an axle adapter  at
the bottom of the back frame .
1. Loosen the fixing screws .
2. Turn the axle adapter  to the front or back until
the desired position.
3. Tighten the screws properly .
4. Adjust the brakes.
1. Remove the screws  and .
2. Push/Pull the adjustable axle adjuster 
2 upwards or downwards to the required
height or mount the rear wheel in another
axle mounting .
3. Retighten the screws  and .
4. Adjust the brakes.
Please note that your wheelchair might
become tipping over. To prevent this, you can
also mount an anti-tipping device.
3
Page 19
Eclips X4 kids 90°
2014-08