Adjusting The Wheelchair To The User; Seat Height - Vermeiren Trigo S Manual De Instalación

EN
NL
3.2

Adjusting the wheelchair to the user

CAUTION
•
Take the possible rear wheel-front wheel configurations into account regarding seat height,
PL
as mentioned in Table 1.
•
Make sure that both front wheels and both rear wheels are mounted in the same position.
CS

3.2.1 Seat height

The seat can be raised or lowered by changing the wheel position, diameter of the front wheels,
and diameter of the rear wheels.
To adjust the height of the rear wheel:
1. Remove the rear wheel, using the quick release system.
2. Remove both bolt-nut connections (1) from the rear wheel
attachment cube (2).
3. Slide the attachment cube (2) up/down in the rear wheel support
(3) until the desired height.
4. Fasten the attachment cube (2) by firmly tightening both
bolt-nut (1) connections.
5. Remount the rear wheel.
6. Repeat for the other wheel.
To adjust the height of the front wheel:
1. Remove the M6 screws (4) on both sides of the wheel.
2. Move the wheel up/down in the front fork (5) until the desired
position.
3. Reattach the wheel to the front fork (5) by firmly tightening both
screws (4) in the according hole.
4. Repeat for the other wheel. Make sure that both rear wheels and
both front wheels are adjusted to the same height.
To adjust the angle of the front wheels:
1. Remove the cover (6) of the front wheel attachment.
2. Loosen the M8 screw.
3. Adjust the angle of the front wheel using the toothed clamp (7). The
fork attachment (8) should be perpendicular to the ground.
4. Firmly retighten the M8 screw and place back the cover (6).
5. Repeat for the other wheel. Make sure that both wheels are adjusted to the same angle.
Table 1: Wheel configurations regarding seat height
SEAT HEIGHT FRONT (in mm)
380 390
¡ ¡
3"
¡
4"
5"
6"
Risk of injuries
400 410 420 430 440
¡ ¡ ¡ ¡
¡ ¡ ¡ ¡ ¡
¡ ¡ ¡ ¡
¡ ¡
450 460 470 480 490
¡ ¡ ¡
¡ ¡ ¡ ¡ ¡
¡ ¡ ¡ ¡ ¡
¡ ¡ ¡ ¡ ¡
6
Assembly and adjustments
1
7
6
500 510
¡
¡ ¡
Trigo S, Trigo T
2019-11
2
3
8
5
4