Blackmagic Design Teranex Mini Instrucciones De Funcionamiento página 55

12G-SDI to Quad SDI
12G-SDI to Quad SDI
1
4
Connectors
1 Mini-B USB Port
The USB port lets you connect your converter to a Mac or Windows computer so you
can adjust settings and update your converter's internal software.
2 Switches
Switches on the front of your Teranex Mini let you change settings using the
tip of a pen.
3 LED Status Indicator
The LED glows white when the converter is receiving power and green when a valid
video input signal is detected. When more than one Teranex Mini is connected to your
computer, you can identify your converter using the 'identify' checkbox in Blackmagic
Teranex Setup. When the checkbox is enabled, your converter's LED will flash
on and off.
4 Power
Standard built in IEC C14 connector for 90 – 240 volt AC power supply.
5 SDI Out A
This BNC connector outputs the following signals:
ͽ SD/HD-SDI
ͽ Single link 3G-SDI
ͽ Single link 6G-SDI
ͽ Dual link HD-SDI channel A
ͽ Dual link 3G-SDI Ultra HD channel A
ͽ Quad link HD-SDI Ultra HD channel A
6 SDI Out B
This SDI video output BNC connector outputs the following signals:
ͽ Dual link HD-SDI channel B
ͽ Dual link 3G-SDI Ultra HD channel B
ͽ Quad link HD-SDI Ultra HD channel B
2
5 6
A B
A B
QUAD or DUAL LINK SDI OUT
QUAD or DUAL LINK SDI OUT
ETHERNET PoE+ 12G-SDI IN SDI LOOP OUT
9 10 11
ETHERNET PoE+ 12G-SDI IN SDI LOOP OUT
3
7 8
C D
C D
Teranex Mini – 12G–SDI to Quad SDI 55