Blackmagic Design Teranex Mini Instrucciones De Funcionamiento página 56

7 SDI Out C
The 'SDI Out C' BNC connector outputs quad link HD-SDI Ultra HD channel C.
8 SDI Out D
This BNC connector is used to output quad link HD-SDI Ultra HD channel D.
9 Ethernet PoE+
The Ethernet connector lets you plug your Teranex Mini into a network switch or
computer so you can change settings using Blackmagic Teranex Setup. The Ethernet
port also supports power over Ethernet plus.
10 12G-SDI In
This input supports a 12G-SDI signal on a BNC connector.
11 SDI Loop Out
This BNC connector outputs the incoming 12G-SDI signal so you can feed it through to
other 12G-SDI equipment.
Quad HD split
Your Teranex Mini 12G SDI to Quad SDI converter has multiple ways of sending high bandwidth
image data over relatively low bandwidth connections.
This diagram represents the difference between quad link SDI, where image information is split
between four 3G-SDI cables to form a single Ultra HD image, and quadrant HD split, where
each of four HD screens receives one quarter of a complete image as part of a video wall.
Dual link 6G SDI operates in the same way as quad link, in that one complete signal is split
across multiple cables, except that only two 3G-SDI outputs are used.
A B
QUAD or DUAL LINK SDI OUT
ETHERNET PoE+ 12G-SDI IN SDI LOOP OUT
Quad Link
C D A B C D
QUAD or DUAL LINK SDI OUT
ETHERNET PoE+ 12G-SDI IN SDI LOOP OUT
Quadrant HD
Teranex Mini – 12G–SDI to Quad SDI 56