Dirt Devil Razor Vac UD70350 Manual Del Usuario página 14

Any other servicing should be done by an authorized service representative. If appliance is not
working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it
to a service center prior to continuing use.
WARNING
PROBLEM
Vacuum
won't run
Dust escaping
from vacuum
Smoky/burning
smell detected
Vacuum tools
won't pick-up
NOTE: Any other servicing should be done by an authorized service representative. If appliance
is not working as it should, has been dropped, damaged, left outdoors or dropped into water,
take it to a service center prior to continuing use.
714
To reduce the risk of personal injury - Unplug before cleaning or servicing.
POSSIBLE CAUSE
1. Power cord not firmly
plugged into outlet.
2. No voltage in wall plug.
3. Blown fuse or tripped
breaker.
4. Thermal Protector activated.
1. Dirt cup full.
2. Dirt cup not installed
correctly.
3. Hose not installed correctly.
1. Brush roll is clogged.
1. Hose clogged
2. Dirt cup full
3. One or both filters are
clogged.
4. Release handle/wand to
actuate internal valve.
5. Vacuum not picking
up debris.
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home.
3. Replace fuse/reset breaker in home.
4. Unplug and allow vacuum to cool for 30min.
(This willl reset the thermal protector)
1. Empty dirt cup.
2. Review Dirt Cup removal & replacement.
3. Review Hose installation.
1. Clear/remove debris from brush roll.
1. Remove hose and tools; remove obstruction.
2. Empty dirt cup.
3. Remove both filters and clean.
4. Pull handle up and out of unit.
5. Brush roll could be turned off or the belt
could be broken.