Cleaning And Routine Maintenance - Teka TKS1 710 C Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Cleaning and routine maintenance

Clean the lint filter
Leave the dryer to cool down
1.Open the machine door.
2.Take out the lint filter, pull
upward to take it out.
3.Clean the lint filter; wipe off
the scrap threads accumulated
on the lint filter, with your hand or
rinse with water and dry thoroughly.
4.Reinstall the lint filter.
NOTE!
.
1.The lint filter accumulated on the filter will block the air circulation, which
will cause the extension of drying time and energy use; therefore, the scrap
thread filter shall be cleaned after each use.
2.Do disconnect the power cord before cleaning!
3.Do not operate the dryer without the lint filter !
4.Clean the lint filter after each use to prevent lint accumulation inside the dryer.
Wash air condenser
-Leave the dryer to cool down.
-Residual water may escape,place an absorbent
cloth under the maintenance flap.
1.Unlock the maintenance flap.
2.Completely open maintenace flap.
3.Screw both locking levers towardas each other.
4.Pool out the air condenser.
5.Clean the air condenser completely, drain thoroughly.
6.Clean the seals.
7.Re-insert the air condenser, handle at the button!
8.Unscrew both locking levers.
9.Cloth the maintenance flap until it locks into position.
Please clean the air condenser approx, once every 3
months if frequently used.
Do not damage the air condenser!
1.Clean with water only; do not use
!
hard/sharp-edged objects! Do not operate
the dryer without the air condenser!
2.During drying, water may collect between the window
and the seal, but this does not affect the function of your dryer!
15

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido