Switching On And Off; Brake And Free-Wheel Lever - Vermeiren Sedna Manual De Instrucciones

EN
NL
3.2
The way the scooter is switched on and off is described in next points. The numbers in
parenthesis can be found in figure 3.
Switching ON with ON/OFF
switch (27)
Switching
ON/OFF switch (27)
Switching
OFF (time)
3.3
3.3.1 Explanation
Your scooter is equipped with electromagnetic brakes. These brakes function automatically,
only if free-wheel lever (14) is in rear position, see figure 6. In this situation, the brakes start
braking if:
•
de scooter is OFF;
•
de scooter is ON and the operating levers are released;

Switching on and off

Put the key in switch (27) and turn it clockwise (ON).
The status indicators (21) light up for some seconds when the
key is turned (during self-test). Battery indicator (24) stays
visible. See also §3.5.1.
OFF with Turn the key in switch (27) counter clockwise (OFF) and
remove the key. The lights of status indicator (21) extinguish.
The scooter will be switched off automatically if it hasn't been
automatically
used for 30 minutes.
To start the scooter again:
•
•
•
•

Brake and free-wheel lever

Operating free-wheel lever
Turn the key counter clockwise.
Remove the key from the ON/OFF switch (27).
Put the key back in the switch.
Turn the key clockwise (ON).
Free-wheel lever (14):
•
Push lever to the FRONT (position A) to
put the scooter in free-wheel mode.
Now, the motor is disconnected. The
scooter can be moved manually.
•
Push lever to the REAR (position B) to
connect the motor to the drive. This
should be done before starting the
scooter.
EN - 14
Sedna
2019-02
Using your scooter