Names And Functions Of Parts; Front Panel - Tascam MZ-223 Manual Del Usuario

Names and functions of parts

Front panel

MIC 1–2 INPUT jacks
1
These XLR/TRS combo jacks are for mic input.
OUTPUT SELECT switches
2
Use these to select outputs for audio input
through the MIC 1–2 INPUT jacks (
MIC 1–2 INPUT VOLUME knobs
3
Use to adjust the mic input level from the MIC 1–2
INPUT jacks (
).
1
PEAK indicators
4
These are mic input peak level indicators for the
MIC 1–2 INPUT jacks (
When adjusting the MIC 1–2 INPUT VOLUME jack
knobs ( ), these light just before the mic input
3
signals distort.
MIC 1–2 INPUT indicators
5
These are mic input level indicators for the MIC
1–2 INPUT jacks (
1
MIC 1–2 INPUT EQ knobs
6
These 3-band (HIGH/MID/LOW) equalizers adjust
the mic input sounds.
MIC 1–2 switches/indicators
7
Press to turn mic input from the MIC 1–2 INPUT
jacks ( ) on/off.
1
The MIC 1–2 indicators light when mic input is on.
Channel faders
8
Use these to adjust the send levels of channel sig-
nals.
PEAK indicators
9
These indicators show the input peak levels of in-
put channels.
When adjusting the 1-5 GAIN knobs (
back of the unit, these light just before the input
channel signals distort.
8
TASCAM MZ-223
).
1
).
1
).
j
SOURCE SELECT switches/indicators
0
Use these to set the LINE A or B input jacks (
the back of the unit as the input sources.
The indicators for the selected inputs light.
OUTPUT VOL knobs
q
Use these to adjust the output levels of the MAIN
OUTPUTS 1–3 (UNBALANCED) (
OUTPUTS 1–3 (BALANCED) (
of the unit.
Output level indicators
w
These indicators show the output levels of the
MAIN OUTPUTS 1–3 (UNBALANCED) (
MAIN OUTPUTS 1–3 (BALANCED) (
back of the unit.
OUTPUT EQ knobs
e
Use these 3-band (HIGH/MID/LOW) equalizers to
adjust the sounds of the MAIN OUTPUTS 1–3 (UN-
BALANCED) (
ANCED) (
MONITOR SELECT switches
r
Use these to select the signals output from the
MONITOR OUT (
The indicators for the selected outputs light.
POWER indicator
t
This shows the status of the unit.
When the POWER (
unit is on, the POWER indicator lights.
TALKOVER DAMP knob
y
Use this to adjust the attenuation level of the talk-
over function.
TALKOVER TIME knob
u
) on the
Use this to adjust the response time of the talk-
over function.
c
) and MAIN OUTPUTS 1–3 (BAL-
v
) jackson the back of the unit.
c
) jacks.
x
) switch on the back of the
f
) on
b
) and MAIN
v
) jacks on the back
) and
v
) jacks on the
c