Panasonic EYFPA1J Manual De Instrucciones página 14

• Use figures from the Tightening Torque
EN EN
Chart to guide your selection of torque
clutch setting. (See the following tighten-
ing torque chart)
. Press the OK button to accept the select-
ed torque clutch setting.
The control panel will stop flashing and
light up.
CAUTION:
• You must press the OK button in order
for the selected setting to take effect.
• Be sure to verify the new value after
changing the setting.
Tightening Torque Chart (for
reference use)
The values illustrated on this chart were mea-
sured under the conditions described below
and are provided for reference purposes.
Actual tightening torque varies with ambient
conditions (the particular bolt being tightened,
hardware being used, method of holding the
bolt in place, etc.).
N·m (kgf·cm / in·lbs)
700 (7140 / 6200)
600 (6120 / 5310)
500 (5100 / 4430)
400 (4080 / 3540)
300 (3060 / 2660)
200 (2040 / 1770)
100 (1020 / 890)
0
1 1 5
EYFNA1C, EYFNA1CR, EYFNA1J,
EYFNA1JR, EYFNA1P, EYFNA1PR
N·m (kgf·cm / in·lbs)
300 (3060 / 2660)
250 (2550 / 2210)
200 (2040 / 1770)
150 (1530 / 1330)
100 (1020 / 890)
M12
50 (510 / 440)
0
1 1 5
Setting the snug point detec­
tion level
[Fig.23]
EYFPA1J, EYFPA1JR
M20
M18
M16
10 15 20
Torque setting level
M14
10 15 20
Torque setting level
1. Press the A button.
The snug point detection level setting
value will be displayed.
[Fig.24]
. Press the
snug point detection level for the work
you're performing.
3. Press the OK button to accept the number
of torque stages and the snug point detec-
tion level.
The tool's panel will flash and then light up
continuously.
Snug point detection level guide­
lines
Display
detection level
characterized by
L1
low loads before
the snug point is
M24
L
CAUTION:
25 30
• Set the snug point detection level from
"L1." Setting the snug point detection
level from "L" may result in cracking or
deformation of the target material.
• If the tool stops before the snug point at
snug point detection level "L1," set the
M18
snug point detection level to "L."
• Changing the snug point detection
M16
level from "L1" to "L" may increase the
torque. Set the number of torque stages
again after making this change.
• The setting will not be changed until
you press the OK button.
25 30
• After changing the setting, be sure to check
the new setting value. (See page 17.)
IMPORTANT INFORMATION:
• You can set the snug point detection
level and retightening prevention time at
the same time by changing the retight-
ening prevention time (See page 14)
- 14 -
and buttons to set the best
Snug point Applications
(reference)
Low
(Use for work • Tightening bolts in
materials that are
easily cracked or
deformed, etc.
reached.)
• Tightening bolts
High
in materials with
(Use for work
misaligned holes,
characterized
etc.
by high loads
before the
• Tightening self-
snug point is
tapping screws,
reached.)
etc.