How to Assemble the Bowl
WARNING: Be sure the unit is unplugged before putting on or taking off any parts.
Put the bowl on top of the food processor base,
with the work bowl handle to the right. Turn the
bowl clockwise until the bowl clicks into place.
The handle should now be to the right of the
control panel. (Figure 2)
Select the appropriate attachment and assemble
onto food processor as directed in the chopping,
kneading or slicing/shredding sections. Place
food or dough in bowl if using multipurpose
blade or dough blade.
NOTE: There is only one position for the bowl to
lock onto the base. The unit will not operate if the
bowl does not lock onto the base.
How to Lock the Cover
Place the lid on the bowl. Turn clockwise until the lid
clicks into place; the arrow on the lid will line up with
the arrow on the handle. Your food processor features a
safety interlock system. The unit will not operate unless
the bowl and bowl cover are properly aligned and
locked into place and the large food chute is engaged.
(Figure 3)
NOTE: Bowl must be locked into base before cover
can be locked into position.
www.oster.com
6
FPSTFP1355_14ESM2.indd 6-7
How to Chop
CAUTION: Make sure the unit is turned OFF and unplugged before use. Never
use hand to push food into processor. Do not use the processor continuously
for more than 3 minutes at a time.
Multipurpose Blade: Use multipurpose blade for
chopping, mixing, blending, pureeing and preparing puff
pastry, crumbs and short crust pastry.
1 Lock the bowl onto base.
(See "How to Assemble the Bowl")
2 Take the disc stem and slide it onto the center post.
Then grasp the multipurpose blade by its stem and
slide over the disc stem. (Figure 4)
CAUTION: Chopping Blade is very sharp, use caution
when handling.
3 Place food into bowl.
Figure 2
4 Lock cover onto bowl. (See "How to Lock the Cover")
5 Place the food pusher into the feed tube.
6 Plug the cord into an electric outlet.
Use the Food Guide to prepare food for
chopping.
7 Press the Slice/Shred, Mix/Knead, or
Chop/Pulse button. When using the
Chop/Pulse setting, hold down the
Chop/Pulse button for about 2–3
seconds at a time, check results and
repeat if desired.
8 When finished processing, press the OFF button and allow the chopping
blade to stop rotating.
Figure 3
9 Twist the cover counter-clockwise to remove lid.
10 Hold the disc stem with multi purpose blade attached by its stem and
remove. Unlock the bowl by turning it counter- clockwise towards the
UNLOCK
mark, and lift off. Empty the processed food.
www.oster.com
Figure 4
7
17/10/14 8:54 AM