To Sharpen The Cutters; To Adjust The Depth Gauge Setting; General Information About How To Adjust The Depth Gauge Setting; To Adjust The Tension Of The Saw Chain - Husqvarna T535i XP Manual Del Usuario

Ocultar thumbs Ver también para T535i XP:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

will help you to keep maximum cutting performance and
the kickback risk at a minimum.
WARNING: The force of the kickback
increases a lot if you do not follow the
sharpening instructions.
To sharpen the saw chain on page 20 for
Note: Refer to
information about sharpening of the saw chain.

To sharpen the cutters

1. Use a round file and a file gauge to sharpen the
cutting teeth.
Accessories on page 27 for
Note: Refer to
information about which file and gauge that
Husqvarna recommends for your saw chain.
2. Apply the file gauge correctly on to the cutter. Refer
to the instruction supplied with the file gauge.
3. Move the file from the inner side of the cutting teeth
and out. Decrease the pressure on the pull stroke.
4. Remove material from one side of all the cutting
teeth.
5. Turn the product around and remove material on the
other side.
6. Make sure that all cutting teeth are the same length.
General information about how to adjust the
depth gauge setting
The depth gauge setting (C) decreases when you
sharpen the cutting tooth (A). To keep maximum cutting
performance you must remove filing material from the
depth gauge (B) to receive the recommended depth
gauge setting. See Accessories on page 27 for
instructions about how to
22
receive the correct depth gauge setting for your saw
chain.
WARNING: The risk of kickback increases if
the depth gauge setting is too large!

To adjust the depth gauge setting

Before you adjust the depth gauge setting or sharpen
To sharpen the cutters on page 22 ,
the cutters, refer to
for instructions. We recommend you to adjust the depth
gauge setting after each third operation that you
sharpen the cutting teeth.
We recommend that you use our depth gauge tool to
receive the correct depth gauge setting and bevel for the
depth gauge.
1. Use a flat file and a depth gauge tool to adjust the
depth gauge setting. Only use Husqvarna depth
gauge tool to get the correct depth gauge setting and
bevel for the depth gauge.
2. Put the depth gauge tool on the saw chain.
Note: See the package of the depth gauge tool for
more information about how to use the tool.
3. Use the flat file to remove the part of the depth
gauge that extends through the depth gauge tool.

To adjust the tension of the saw chain

WARNING: A saw chain with an incorrect
tension can come loose from the guide bar
and cause serious injury or death.
A saw chain becomes longer when you use it. Adjust the
saw chain regularly.
A
C
B
959 - 007 -

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido