To Remove A Trapped Product; Maintenance; Maintenance Schedule - Husqvarna T535i XP Manual Del Usuario

• Use a foot loop to keep a safe work position.
• Do a check of the harness, belt and ropes at a
regular interval.
• If you must climb with the product, attach the product
to the rear connection point on the harness. The rear
connection point keeps the product clear from
climbing lines and makes sure that the weight has
central support down your spine.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.

Maintenance schedule

WARNING: Remove the battery before you
do maintenance.

Maintenance

Clean the external parts of the product.
Make sure that the power trigger and the power trigger lockout function correctly
from a safety point of view.
959 - 007 -

To remove a trapped product

1. Stop the product.
2. Attach the product safely to the tree inboard, against
the trunk side, of the cut or a different tool line.
3. Carefully pull the saw away from the kerf while you
lift the branch as necessary.
4. If it is necessary, use a hand saw or a second
chainsaw to release the product. Cut the branch at a
minimum of 30 cm/12 in from the caught product.
Make the cut on the outer end from where the
product is caught.
Maintenance
The following is a list of the maintenance steps that you
must do on the product. See
for more information.
WARNING: You must engage the chain
brake when you lower the product onto
its strop.
WARNING: Do not try to pull the product
free. Risk of serious injury.
Maintenance on page 17
Before
Weekly
use
X
X
Monthly
17