Assembly And Adjustments - DeWalt D28474 Manual De Instrucciones

643855-00,D28474,B3 10/3/06
054339-00 Grinding backing flange
22191-00 Clamp nut
61820-01 Wheel Wrench
445928-01 Soft mount spindle protector
397711-00 Rubber gear case bumper

ASSEMBLY AND ADJUSTMENTS

Attaching the Side Handle
To install the side handle, thread the handle into one of the five
positions listed below and tighten securely by turning clockwise.
• Two front positions: Forward handle positions are designed
for optimized balance in surface finishing applications.
• Two rear positions: Rear handle positions are designed for
optimized balance in edge grinding applications.
• One top position: Top handle position is designed for edge
grinding applications.
NOTE: D284076 includes only three handle positions.
Rotating the Rear Handle
Turn off and unplug tool before making any adjustments or
removing or installing accessories.
Before reconnecting the tool, depress
and release the trigger switch to ensure
that the tool is off.
1. Unlock the rear handle by pulling out
the Handle Release Lever (G) as
shown.
2. Rotate handle into available 0°, 30°,
60° or 90° position left OR right of
center.
3. Push in the handle release lever.
11:38 AM Page 8
4. Before turning the tool on, ensure that the handle is locked into
a position and the handle release lever has returned to the orig-
inal position flush with the tool housing.
Rotating the Gear Case
Turn off and unplug tool before making any adjustments or
removing or installing accessories. Before reconnecting the
tool, depress and release the trigger switch to ensure that the
tool is off.
1. Remove the four corner
screws attaching the gear
case to motor housing.
2. Without separating the gear
case from motor housing,
rotate the gear case head to
desired position.
NOTE: If the gear case and motor housing become separated by
more than 1/8", the tool must be serviced and re-assembled by a
D WALT service center. Failure to have the tool serviced may
E
cause brush, motor and bearing failure.
3. Re-install screws to attach the gear case to the motor housing.
Tighten screws to 20 in lbs torque. Overtightening could cause
screws to strip.
OPERATION
Power Source
Plug the Large Angle Grinder into a dedicated electrical circuit.
Operating this tool on a circuit with other tools will decrease tool
performance.
Switch
CAUTION: Before connecting the tool to a power source or after
a power failure, depress and release the trigger switch (A) once
8
G