Symbols - KPS CF100 Manual De Instrucciones

• Be careful when working above 30 V ac rms, 42 V
ac peak and 60 V dc. Such voltages pose a shock
hazard.
• When using the probes, keep fingers away from
probe contacts. Keep fingers behind the finger
guards on the probes.
• Measurements can be adversely affected by
impedances of additional operating circuits
connected in parallel or by transient currents.
• Verify operation on a known source prior to
measuring hazardous voltages (voltages above
30 V ac rms, 42 V ac peak and 60 V dc).
• Do not use the apparatus with any of the parts
removed.
• Do not use the apparatus around explosive gas,
vapor, or dust.
• Disconnect the test leads from power sources and
the apparatus before changing the battery.
• Do not use the apparatus in a wet environment.
03

Symbols

The following symbols appear on the Motor and
Phase Rotation Indicator or in this manual.
Table 1. Symbols
Caution, risk of danger
Earth(ground)
Alternating current
Direct current
Complies with European
(EU) safety standards
Equipment protected
throughout by DOUBLE
INSULATION or
REINFORCED INSULATION
CONFORMS TO UL STD.
61010-1,61010-2-030,
61010-031; CERTIFIED TO
CSA STD.C22.2 No.61010-1，
61010-2-030, 61010-031
CAT III: MEASUREMENT CATEGORY III is applicable to
test and measuring circuits connected to the distribution
part of the building's low-voltage MAINS installation.
04
TERMINAL