Pioneer X-SMC3-K Manual De Instrucciones página 39

Sistema micro slim av
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Additional information
Wireless LAN
Problem
Network cannot be accessed
via wireless LAN.
Check
Is Network Type set to Auto and
the LAN cable connected to the unit?
This unit and base unit (wireless LAN
router, etc.) are too far apart or there
is an obstacle between them.
There is a microwave oven or other
device generating electromagnetic
waves near the wireless LAN
environment.
Multiple wireless devices are
connected to the wireless LAN
router.
Wireless LAN connections cannot be
established between the unit and
base unit (wireless LAN router, etc.).
The IP address settings of the unit
does not match the settings of the
wireless LAN router, etc.
The access point is set to conceal the
SSID.
The access point's security settings
use WEP 152-bit length code key or
shared key authentication.
Remedy
Switch Network Type to Wireless or disconnect the LAN cable
from the unit, then restart the unit.
If Network Type is set to Auto and the LAN cable is connected to
the unit, the unit recognizes the Network Type as Wired.
Improve the wireless LAN environment by moving the unit and base
unit closer together, etc.
Use the system in a place away from microwave ovens or others
device generating electromagnetic waves.
Avoid using devices generating electromagnetic waves as much as
possible when using the system with the wireless LAN.
When connecting multiple wireless devices, their IP addresses
must be changed.
The unit must be set in order to establish wireless LAN
connections. See Connecting using wireless LAN on page 8.
Check the IP address settings of the unit (including the DHCP
setting).
If the unit's DHCP setting is on, turn the unit's power off, then turn
the power back on.
Check that the IP addresses of the unit match the settings of the
wireless LAN router, etc.
If the unit's DHCP setting is off, set an IP address matching the
network of the base unit (wireless LAN router, etc.).
For example, if the wireless LAN router's IP address is
"192.168.1.1", set the unit's IP address to "192.168.1.XXX" (*1), the
subnet mask to "255.255.255.0", the gateway and DNS to
"192.168.1.1".
(*1) Set the "XXX" in "192.168.1.XXX" to a number between 2 and
248 that is not assigned to other devices.
In this case, the SSID may not be displayed on the access point list
screen. If not, set the SSID, etc., by making the wireless LAN
settings on the unit manually.
The unit does not support WEP 152-bit length code key or shared
key authentication.
13
39
En

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

X-smc3-s

Tabla de contenido